Cellwood PG50SAMPLE N3 Installationsanleitung PDF herunterladen (Seite 68)

round cut installation

Securing Panels Around

Windows

• Measure and cut panels around

windows, allowing ¼˝ into all win-

dow channels for movement. (see

Figure 16).

• Make sure to install water diverters

at the bottom corners of the

window (refer to Basic Accessory

Installation Section “Installing

J-Channel, Flex-J and Flashing”).

• Use a nail slot punch to create nail

slots every 8˝ on the cut edge of the

panel.

• Furr as needed.

• Slide panel into window channel.

• Pull up tight and nail according

to “NAILING PROCEDURES”

(window channel must conceal

nail-heads).

Installation Tip: A nail set can be

used to ease installation.

Installing Final Course

NOTE: A crown molding, J-channel

or wide window casing can be used in

eaves and gables to receive the final

course (see Figure 17).

• Measure the required width for

last course less ¼˝ to allow for panel

movement.

• Cut panel height as required.

• Punch nail slots every 8˝.

• Nail through center of slots.

NOTE: Furring may also be required.

Fig.16

Fig.17

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 89 90

Keine Kommentare

Cellwood PG50SAMPLE N3 Installationsanleitung Seite 68